• Help support Chopped Baggers :

What exhaust to run??

Chops603

One of THE 150!
So I am going to be running duals on my 05 EG with baddad's rear fender/stretched bags with dual cut outs... Looking for some input on exhaust, I notice they sell slip ons. Anyone running them? That is the look that I like, just plain 4''. No visible baffle or rounded over tips etc. Any help/info would be appreciated.

http://www.baddad.com/products/part/80874
 

Buggy

One of THE 150!
The kuryakin crushers are big and have a unique sound. I prefer vace & hines personally
 

Bill

I used to own some shit!
I have some 4" Drago's mufflers coming. They are available in a few different end styles "slash up, down, straight."

They are the Rush muffler body with a better baffle in them.
 

808Bagger

Well-Known Member
So I am going to be running duals on my 05 EG with baddad's rear fender/stretched bags with dual cut outs... Looking for some input on exhaust, I notice they sell slip ons. Anyone running them? That is the look that I like, just plain 4''. No visible baffle or rounded over tips etc. Any help/info would be appreciated.

http://www.baddad.com/products/part/80874
Yo Chop! When you get your parts from BadDad, they may give you a calendar with your order. Do me a favor, check out December Bike! hehehehehehe!
 

Chops603

One of THE 150!
Thanks for the replies, 808Bagger no calendar. I have had my parts from them in my basement for a few months.
 

Chops603

One of THE 150!
Also, I don't know too much about whatever I have going on for exhaust now. Anyone have any idea?? I could be wrong, but these don't seem stock to me.

IMAG0105-2.jpg

IMAG0102-1.jpg

IMAG0108-1.jpg
 

Nova606

One of THE 150!
I have a Klock Werks 2 into 1 that needs powder coating or ceramic coating. Two sets of heat shields and muffler body. Sounded better than D&D as it sounds more tuned. Definitely sounded good when you turned the right wrist!!! No problem listening to stick radio with this exhaust while cruising. Made decent power. With HD Race Tune, Heavy breather and this exhaust the Dyno was 80 or 81 hp.... I went with V&H big rads as I wanted to see more of the rear wheel on my bike while it is parked and lowered. The exhaust has a stainless steel end cap that has been brushed/ polished... I tried to Powder coat the heat shields but the oven that I used was not large enough and having the door open did not get the powder coat hot enough. Long story there.. Here is a picture of the exhaust on the bikeside shot.jpg. I am thinking $400.00 shipped with all sets of heat shields. Depends on what size box I can get it all in but we can figure that out if interested.
 
Top