Getting ready to put on 10" bars Advice???

  • Help support Chopped Baggers :

Josh1

Well-Known Member
Messages
437
Location
Palm Shores FL.HX
Hey guys getting ready to put on my 10" bars this weekend, while I am at it I will do the sound system and powder coat the front end, and lower it.
Just want any tricks or tips before I pull the trigger, I have 1 1/2 bars from vindikta and they are insane the craftsman ship is flawless. So if you have done them and have some advice I am all ears.
Oh and from what I have heard I don't need to extend anything just remove molex connector and T.B.W connectors and should be good!

Thanks in advance, you guys are the shit!
 

rollinrooster

Well-Known Member
Messages
291
Location
East Tn
Congrats on the bars!!!! what style did you get? Your correct in that you dont have to extend the wires for 10" bars. My best advice is to lube the shit out of the wires and lots of patience and you will be fine. Good luck.
 

Bill

I used to own some shit!
Messages
7,115
Location
Omaha NE
You may have to delete the rubber trim between the bars and dash piece.

Sent from my ADR6400L using Tapatalk 2
 

Josh1

Well-Known Member
Messages
437
Location
Palm Shores FL.HX
Thanks gents, Nice one Addictj LOL!!!!!
I will start a build thread, when I get some time, my two boys keep me very very busy!
Between my 4 year old and 9 month old, once they go to bed its straight to the garage! With the baby monitor of coarse!!! LOL
 
Top