• Help support Chopped Baggers :

Dropping off tomorrow

Sonic69

One of THE 150!
The SG is getting dropped off at the shop saturday morning. I know I got a bike or two in front of me, but I want to know what numbers my 113 with the new Dragula is putting up. Driving me crazy.:22:
 

QuikHD

One of THE 150!
I know the feeling! I finished up my 124" in January, rode it up and down my street, pulled it back on the lift and cut the neck off! The motor was still pretty fresh, so I coudnt even rip on it. Hope to get it dyno tuned in a few weeks
 

Sonic69

One of THE 150!
Don't know. Didn't want to ride it without the tune. I was there yesterday and he said within the next week I was getting done. Man they had alot of bikes in there. A little warm weather brings them out.
 

coolerman69

One of THE 150!
Don't know. Didn't want to ride it without the tune. I was there yesterday and he said within the next week I was getting done. Man they had alot of bikes in there. A little warm weather brings them out.
Damn you have more self controll than I do! I would have been trying to get it up on the back wheel!
 

Sonic69

One of THE 150!
They finally got on it wednesday. Once on the dyno it was only going to 40%. The code for the throttle by wire came up with 3 other codes. Were thinking the wire might of got damaged inside the bars, so today the bars have to come off and pull all the wiring back out to check them. Nothing can be a easy process for me right now. Once we fix that it will be back on the dyno.
 

Bill

I used to own some shit!
Good to hear they are working on it.

Sucks to hear about the tbw wires...

Sent from my ADR6400L using Tapatalk
 
That sucks also we have found use some die grease on the throttle connector at throttle body some times that will act funny just had that on dyno Sat. And we did not touch handle bars are stock


They finally got on it wednesday. Once on the dyno it was only going to 40%. The code for the throttle by wire came up with 3 other codes. Were thinking the wire might of got damaged inside the bars, so today the bars have to come off and pull all the wiring back out to check them. Nothing can be a easy process for me right now. Once we fix that it will be back on the dyno.
 

Bill

I used to own some shit!
I might be able to start it this week though.

Sent from my ADR6400L using Tapatalk
 

Latest posts

Top