26 vs. 30 input needed

[e9turbo]

I first would like to thank you all for your valuable information. This site has proven to be very helpfull. So the question I do have is I do know the question has been brought up but would like to revistit it.

26 or 30 inch what is ridable differences, also I have prepared gathered almost everything just frontend is and wheel is needed. If we do look at two different bikes. The first being a preference of mine. I do know that they "HHI" does recommend a 4 over on the fork legs for a 30 inch. Is this nessesary I was thinking 2 over on tubes. But looking at these bikes they do look a bit different. Functionality does matter in the build any suggestions would help. To every person on this site that is riding, enjoying their bikes the way they want them, Thank you for your creativity and expression on two wheels

http://www.americanbagger.com/pdf/60blackmamba.pdf

http://choppedbaggers.com/forums/showthread.php?668-30-quot-wheel-on-road-glide-in-process/page5


So do we have any vendors on this site for wheels 3D. I was thinking for going with MIDEVIL CYCLES.
4500 30inch wheel 2D, 17. 6.25 rear wheel to match, fender, rotors, brackets to move stock calipers to 13inch location, and trees if I do want them. Any thoughts on this vendor.

Thank all the best

E9 turbo

 

[AddictJ]

They donte make adapter for right side caliper to fit a 13 rotor. Just left side

 

[Thomason Performance]

So do we have any vendors on this site for wheels 3D. I was thinking for going with MIDEVIL CYCLES.
4500 30inch wheel 2D, fender, rotors, brackets to move stock calipers to 13inch location, and trees if I do want them. Any thoughts on this vendor.

Thank all the best

E9 turbo

Yes we do! If I can help you out with any of your wheel concerns be sure to give me a shout. A forum member here has a 3D 30" that I machined for him. Let me know if there is anything I can do to help!

Thanks,
Greg